Owner's Manual

3
REV. 10/8/21 INSTAXTC-FD3
PROGRAMMI NG
1. Open the driver’s door, and keep open during the programming process.
2. Cycle the ignition on and wait (5) seconds.
3. Connect the AXTC-FD3 harness to the AXTC-FD3 interface, and then to
the wiring harness in the vehicle.
4. Locate the Volume Up button on the steering wheel. Program the interface
by tapping the Volume Up button at a heartbeat pace until the LED light
stops flashing.
5. The LED light will flash Green & Red while the interface programs the
radio to the steering wheel controls. Once programmed, the LED light will
go out, then produce a pattern which will identify the radio type installed .
6. The LED light will go out, then once again quickly flash Green & Red
while the interface programs itself to the vehicle. Once programmed,
the LED light will go out again, then turn solid Green.
7. Cycle the ignition off, then back on.
8. Test all functions of the installation for proper operation.
Green & Red LED
Green or Red LED
Green & Red LED
Green LED
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
O
F
F
A
C
C
O
N
S
T
A
R
T
VOL
+
Tap Volume Up