Instructions

ManualsBrandsMetra ManualsCar HarnessMetra Range Rover w/ MOST25 Amp 2006-2012

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

AXDIS-LR82

INSTALLATION INSTRUCTIONS

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Wire cutter • Crimp tool • Solder gun • Tape

• Connectors (example: butt-connectors, bell

caps, etc.)

TABLE OF CONTENTS

Connections to be made .......................................2

Installing the AXDIS-LR82 interface .....................3

Programming the AXSWC interface .....................3

Land Rover Range Rover Vogue (with M.O.S.T. 25 ampliﬁer) Data Interface with SWC 2006-2012*

• Provides accessory power

• Designed for ampliﬁed models

• Provides NAV outputs (parking brake, reverse, speed sense)

• Retains audio controls on the steering wheel

• Micro-B USB updatable

• AXDIS-LR82 interface

• AXDIS-LR82 ampliﬁer interface

• AXSWC interface

• AXDIS-LR82 harness

• AXSWC harness

• M.O.S.T. jumper harness

• Female 3.5mm connector with stripped leads

* Facelift models, with touchscreen

Summary of content (4 pages)

PAGE 1
AXDIS-LR82 I N S TA L L AT I O N I N S T R U C T I O N S Land Rover Range Rover Vogue (with M.O.S.T.
PAGE 2
CONNECTIONS TO BE MADE From the aftermarket radio to the AXDIS-LR82 harness: • Connect the Black wire to the ground wire. • Connect the Yellow wire to the battery wire. • Connect the Red wire to the accessory wire. • If the aftermarket radio has an illumination wire, connect the Orange wire to it. • Connect the Blue wire to the power antenna turn-on wire. The following (3) wires are only for multimedia/navigation radios that require these wires. • Connect the Blue/Pink wire to the VSS/speed sense wire.
PAGE 3
INSTALLING THE AXDIS-LR82 INTERFACE With the key in the off position: • Connect the AXDIS-LR82 harness to the AXDIS-LR82 interface. • Connect the AXDIS-LR82 harness to the AXDIS-LR82 amplifier interface. • Remove the dust cover from fiber optic port in the AXDIS-LR82 amplifier interface. • Connect the factory fiber optic cable into the AXDIS-LR82 amplifier interface. * • Connect the AXDIS-LR82 harness to the wiring harness in the vehicle.
PAGE 4
AXDIS-LR82 I N S TA L L AT I O N I N S T R U C T I O N S PROGRAMMING THE AXSWC INTERFACE IMPORTANT (CONT.) If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.