Owner's Manual

PROGRAMMING

Programming the AXSWC Interface

1. Connect the AXSWC to the AXDIS-PO13 harness.

2. Press and hold the Volume Up button on the steering wheel.

3. Turn the ignition on. The L.E.D. in the AXSWC interface will start ﬂashing rapidly, as the

AXSWC interface searches for the auto manufacturer.

4. After a few seconds the L.E.D. should stop ﬂashing rapidly, then go out for approximately (2)

seconds.

5. After that (2) seconds there will be a series of (7) Green ﬂashes, some short, and some

long. The long ﬂashes represent the wires that are connected from the vehicle to the AXSWC

interface. The 3rd, 4th, 5th, and 6th ﬂashes should be longer.

6. The L.E.D. will pause for another (2) seconds, then begin ﬂashing Red (up to 23 times) as the

AXSWC interface locates the aftermarket radio installed. Refer to the L.E.D Feedback Legend

for the number of times the light should ﬂash for the radio installed.

7. This is the end of the auto detection stage. If the AXSWC interface detected the vehicle

and radio successfully, the L.E.D. will light up solid Red. If not, refer to the troubleshooting

documents available at axxessinterfaces.com.

8. Release the Volume Up button. Test all functions of the installation for proper operation

before reassembling the dash. Refer to the Steering Wheel Control documents available at

axxessinterfaces.com for customizing the buttons, if so desired.