Owner's Manual

REV. 10/4/21 INSTAXDIS-PO13

Installing the AXDIS-PO13 Interface:

With the key in the off position:

• Connect the AXDIS-PO13 harness to the AXDIS-PO13 interface.

• Connect the AXDIS-PO13 harness to the AXDIS-PO13 MOST ampliﬁer interface.

• Connect the AXDIS-PO13 harness to the wiring harness in the vehicle.

• Connect the USB retention harness from the vehicle to the aftermarket radio.

• Connect the AXSWC harness to the AXSWC interface, and then to the AXDIS-PO13 interface.

Installing the Fiber Optic Cable:

Removal of the original ﬁber optic connection is required to adapt to the Media Oriented

System Transport (MOST) interface. The black connector housing uses a different keyway than

the MOST interface.

• From the original Fiber Optic Connector: Using a pick tool, carefully pull this tab towards

the outside edge for the connector housing. Gently remove the

ﬁber optic insert from the

connector. (Figure A)

• From the MOST Interface: Using the same steps from above, remove the gray insert from the

black ﬁber optic housing. Replace the gray connector with the ﬁber optic cables into the MOST

interface’s black connector housing. (Figure B)

• Plug the MOST connector into the ﬁber decoder box.

I N STALL ATI ON

(Figure A) (Figure B)