Owner's Manual

ManualsBrandsMetra ManualsAudio accessories & installationAxxess Wiring Interface

AXDIS-PO13

INSTALLATION INSTRUCTIONS

ATTENTION! With the key out of the

ignition, disconnect the negative battery

terminal before installing this product. Ensure

that all installation connections are secure

before cycling the ignition to test this product.

NOTE: Refer to the instructions included with

the aftermarket radio.

INTERFACE FEATURES

INTERFACE COMPONENTS

TOOLS REQUIRED

• Wire cutter

• Crimp tool and connectors

(ex. butt splice connectors, bellcaps, etc.)

• Solder gun, solder, and heat shrink

• Tape

• Zip-ties

TABLE OF CONTENTS

Connections ............................................................2

Installing the AXDIS-PO13 interface ......................3

Installing the Fiber Optic Cable.............................3

Programming the AXSWC interface .....................4

Data Interface with SWC

Porsche (with MOST 25 amp) 2010-2016

APPLICATIONS

• Provides accessory power

• Retains RAP

(retained accessory power)

• Designed for MOST ﬁber

ampliﬁed system

• Retains reverse camera

• Micro-B USB updatable

• Provides NAV outputs (parking

brake, reverse, speed sense)

• Retains steering wheel controls

• Retains balance

Porsche

Panamera 2010-2016 PCM 3.1

Cayenne 2012-2016 PCM 3.1

911 (991) 2012-2016 PCM 3.1

2008-up

Pontiac

Xxxxxxx 2007-2008

Xxxxxxx 2009

• AXDIS-PO13 interface • AXDIS-PO13 harness • AXDIS-PO13 MOST-25 ampliﬁer interface • AXSWC harness • AXSWC interface

• Female 3.5mm connector with stripped leads

Visit axxessinterfaces.com for more detailed information about the product and up-to-date

vehicle speciﬁc applications

Summary of content (6 pages)

PAGE 1
AXDIS-PO13 I N S TA L L AT I O N I N S T R U C T I O N S Data Interface with SWC Porsche (with MOST 25 amp) 2010-2016 Visit axxessinterfaces.
PAGE 2
CONNECTIONS From the AXDIS-PO13 harness to the aftermarket radio, connect as indicated: • Black wire to the ground wire. • Yellow wire to the battery wire • Blue wire to the power antenna wire. • Blue/White wire to the amp turn on wire. • Brown wire to the mute wire. • Orange wire to the illumination. • Red wire to the accessory wire. NOTE: There will an accessory wire from the Steering Wheel Control harness to connect as well.
PAGE 3
INSTALLATION Installing the AXDIS-PO13 Interface: With the key in the off position: • Connect the AXDIS-PO13 harness to the AXDIS-PO13 interface. • Connect the AXDIS-PO13 harness to the AXDIS-PO13 MOST amplifier interface. • Connect the AXDIS-PO13 harness to the wiring harness in the vehicle. • Connect the USB retention harness from the vehicle to the aftermarket radio. • Connect the AXSWC harness to the AXSWC interface, and then to the AXDIS-PO13 interface.
PAGE 4
PROGRAMMING Programming the AXSWC Interface 1. Connect the AXSWC to the AXDIS-PO13 harness. 2. Press and hold the Volume Up button on the steering wheel. 3. Turn the ignition on. The L.E.D. in the AXSWC interface will start flashing rapidly, as the AXSWC interface searches for the auto manufacturer. 4. After a few seconds the L.E.D. should stop flashing rapidly, then go out for approximately (2) seconds. 5. After that (2) seconds there will be a series of (7) Green flashes, some short, and some long.
PAGE 5
PROGRAMMING L.E.D. Feedback: The (23) Red L.E.D. flashes represent a different radio manufacturer for the AXSWC interface to detect. For example, if you are installing a JVC radio, the AXSWC interface will flash Red (5) times, then stop. Following is the L.E.D Feedback Legend, which indicates the flash count of the radio manufacturer L.E.
PAGE 6
AXDIS-PO13 I N S TA L L AT I O N I N S T R U C T I O N S Having difficulties? We’re here to help. Contact our Tech Support line at: 386-257-1187 Or via email at: techsupport@metra-autosound.com Tech Support Hours (Eastern Standard Time) Monday - Friday: 9:00 AM - 7:00 PM Saturday: 10:00 AM - 7:00 PM Sunday: 10:00 AM - 4:00 PM ® KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.