Owner's Manual

AX-LCD
®
3
Connections to be made
The AX-LCD allows the retention of the vehicles personalization menu that is lost after removing the factory radio.
The DIN harness with leads is only for the following vehicles:
Fiat 500L 2014-up, 500X 2016-up / Mazda6 2014-2015 / Ram 1500/2500/3500 (without 8.4” touchscreen radio) 2013-up,
Ram Chassis Cab 3500/4500/5500 (without 8.4” touchscreen radio) 2013-up, Ram Promaster 2014-up, Ram Promaster City 2015-up
Toyota Camry 2012-2014, Toyota Rav-4 2013-up, Toyota Tundra 2014-up, Toyota Venza 2013-2015
• Connect the Black wire to ground. • Connect the Red wire to accessory power.
For all other applications that require the AX-LCD screen, connect the DIN cable from the LCD screen
into the DIN connector on the interface. Skip the following steps for these applications.
(this is the wire view of the factory harness)
For the Toyota Camry 2012-2014, Rav-4 2013-up,
Tundra 2014-up, and Venza 2013-2015
The following connections are to be made to the factory
28-pin connector behind the radio:
• Pink of the AX-LCD to pin-9
• Blue/Pink of the AX-LCD to pin-10
For the Mazda 6 2014-2015
The following connections are to be made to the
factory 24-pin connector behind the radio:
• Pink of the AX-LCD to pin-1L
• Blue/Pink of the AX-LCD to pin-1J
(this is the pin view of the factory harness)
For the Fiat 500L 2014-up, 500X 2016-up,
Ram 1500/2500/3500 (without 8.4” touchscreen radio),
Chassis Cab 3500/4500/5500 (without 8.4”
touchscreen radio) 2013-up,
Promaster 2014-up,
Promaster City 2015-up
The following connections are to be made to the
factory 52-pin connector behind the radio:
31 40 49
52
44
41
10
1
(this is the pin view of the factory harness)
• Blue/Pink of the AX-LCD to pin-12
• Pink of the AX-LCD to pin-2