Installation manual

Like we said before, only one of these actions will need to be done depend-

ing on your vehicle for the auto detect feature to work. Please refer to the

vehicle info sheet in the Axxess website.

These are the steps for the Auto Detect Mode:

1) Complete connections to the vehicle and the aftermarket radio.

* If this is the rst time the ASWC is being installed in a vehicle:

2) Turn the ignition on; the led will start ashing rapidly which means the

ASWC is looking for the vehicle and the radio.

3) Perform action required for your particular vehicle as noted in the vehicle

info sheet.

4) After a couple of seconds the led should stop ashing and not light up for

2 seconds.

At this point do not push any buttons.

5) After the 2 seconds there will be a series of 7 ashes, some short and

some long. Make a note of which ashes were long for this may be

needed later.

6) The led will pause for another 2 seconds then ash up to 9 times. Again

make a note of how many ashes.

7) This is the end of the auto detection stage. If the ASWC detected the

vehicle and the radio successfully the led will light up solid red.

8) Make sure the steering wheel control buttons function correctly in the

vehicle and enjoy your radio.

So what if the led does not light up solid red? Check out troubleshooting

section below.