Installation manual

1st led ash is pin #2 (White/Green) on the ASWC
2nd led ash is pin #3 (Orange/Green) on the ASWC
3rd led ash is pin #4 (Green/Orange) on the ASWC
4th led ash is pin #5 (Gray/Red) on the ASWC
5th led ash is pin #8 (Black/Green) on the ASWC
6th led ash is pin #11 (Gray/Blue) on the ASWC
7th led ash is pin #1 (Pink) on the ASWC
If during the auto detect sequence there was no long led ash, just short
ones, the ASWC was not connected to the correct wire in the vehicle or
the incorrect wire was used on the ASWC. Double check connections and
the vehicle information sheet to verify that you have the correct wires con-
nected.
The 2nd set of led ashes represents what brand radio the ASWC believes
it is connected to. Each ash is for a different radio manufacturer.
1st led ash is for Eclipse
2nd led ash is for Kenwood
3rd led ash is for Clarion
4th led ash is for Sony and Dual
5th led ash is for JVC
6th led ash is for Pioneer and Jensen
7th led ash is for Alpine*
8th led ash is for Visteon
9th led ash is for Valor
10th led ash is for Clarion 5V
* Note: If the ASWC ashes 7 times and you do not have an Alpine radio
connected to it that means that the ASWC did not see any radio connected.
Verify the 3.5mm connector is connected to the SWC input on the radio.
10