Product Datasheet/Brochure

REV. 1/5/2018 INST99-9721
7
ISO DDIN radio provision
1. Attach the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra. Test
the radio for proper operation.
3. Secure the completed assembly into
the dash using the factory hardware.
(Figure B)
4. Unclip and remove the start button
from the factory dash panel, and while
holding the panel in place over the
radio, secure the panel using the
(1) #6 x 1/2”Phillips screw supplied.
(Figure C)
5. Clip the start button back to the
factory dash panel.
6. Reassemble the dash in reverse order
of disassembly.
(Figure C)(Figure A)
(Figure B)
KIT ASSEMBLY