Product Datasheet/Brochure

1.800.221.0932
|
MetraOnline.com
6
ISO DIN radio provision with pocket
1. Attach the pocket to the radio brackets
using the (4) #8 x 3/8” Phillips screws
supplied. (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the radio bracket
assembly and secure with screws
supplied with the radio. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra. Test
the radio for proper operation.
5. Secure the completed assembly into
the dash using the factory hardware.
(Figure C)
6. Unclip and remove the start button
from the factory dash panel, and while
holding the panel in place over the
radio, secure the panel using the
(1) #6 x 1/2”Phillips screw supplied.
(Figure D)
7. Clip the start button back to the factory
dash panel.
8. Reassemble the dash in reverse order
of disassembly.
(Figure C)(Figure A)
(Figure D)(Figure B)
KIT ASSEMBLY