Installation Manual

99-9604
2
1. Unsnap and remove the trim panel
around the outside of the radio, switches,
and climate controls. (Figure A)
2. Remove (4) T-20 Torx screws to remove
the radio. (Figure B)
There are (2) different methods for
installing this kit. Option 1 does not require
the kit to be secured to the sub-dash
bracket whereas option 2 does. If choosing
option 1, skip to kit assembly. If choosing
option 2, proceed to the next step.
3. Using a pick tool, release (2) clips securing
the climate control switches
. (Figure C)
3. Remove (6) T-20 Torx screws to remove
the radio sub-dash bracket: (2) at the
top, (2) at the bottom, and (2) inside the
cavity at the bottom. (Figure D)
Note: It is not necessary to completely
remove the bracket and connectors. Kit
assembly can be performed inside the
vehicle to avoid this if so desired
.
Continue to kit assembly
Dash Disassembly
(Figure B) (Figure D)
(Figure A) (Figure C)