User Manual

ManualsBrandsMetra ManualsOtherMetra 99-9222 VOLVO MULTI KIT 75-94

KIT COMPONENTS

4 5

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

Re-connect the battery terminal and test the unit

for proper operation. Mount the head unit/kit

assembly to the sub-dash with those screws

previously removed in step #1.

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

Radio Housing #1

Radio Housing #2

Radio Housing #3

Spacer

TOOLS REQUIRED

Cutting tool

Flat-blade screwdriver

Phillips screwdriver

200 SERIES (LOWER DASH), 100 SERIES: For 2-Shaft head units, slide the aftermarket

head unit into the Radio Housing and secure with shaft nuts. (see Fig. A). For DIN head units,

cut and remove the shaft supports from the kit. Slide the DIN cage into the kit and secure by

bending the metal locking tabs down. Slide the aftermarket head unit into the cage until

secure. (see Fig. B)

740 SERIES, 760 SERIES: For 2-Shaft head units, slide the aftermarket head unit into the kit

and secure with shaft nuts. (see Fig. C). For DIN head units, cut and remove the shaft supports

from the Radio Housing. Slide the DIN cage into the kit and secure by bending the metal

locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. D)

Fig. A

Fig. B

Fig. C

Fig. D

99-9222

INSTALLATION

INSTRUCTIONS

APPLICATIONS

CAR PAGE

VOLVO

100 Series 1973-75.............................1

200 Series (lower dash) 1975-93.........1

200 Series (upper dash) 1980-93........1

740 Series 1985-92............................ 2

760 Series 1983-88............................ 2

1-800-221-0932 www.metraonline.com

rev. 06-25-07

940 Series 1991-05............................ 2

Summary of content (2 pages)

PAGE 1
KIT COMPONENTS 3b Fig. B Fig. A Radio Housing #1 Radio Housing #2 Fig. C 99-9222 INSTALLATION INSTRUCTIONS Fig. D APPLICATIONS Radio Housing #3 200 SERIES (LOWER DASH), 100 SERIES: For 2-Shaft head units, slide the aftermarket head unit into the Radio Housing and secure with shaft nuts. (see Fig. A). For DIN head units, cut and remove the shaft supports from the kit. Slide the DIN cage into the kit and secure by bending the metal locking tabs down.
PAGE 2
VOLVO 100 Series 1973-75 200 Series (lower dash) 1975-93 1 Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (1) Phillips screw and (1) plastic twist-lock screw securing each side panel to the lower dash console. Remove (2) Phillips screws from the base of the radio trim bezel and remove the bezel. Remove (4) screws securing the factory pocket to the sub-dash and remove the pocket. 2 Locate Radio Housing #1.