User Manual

99-9109B
®
ISO DIN radio provision with pocket
1. Attach the pocket to the radio
brackets using the (4) #8 x 3/8”
Phillips screws provided. (Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Slide the radio into the bracket/
pocket assembly, and then secure it
using the screws supplied with the
radio. (Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or Axxess. Test the radio
for proper operation.
5. Insert the completed assembly into
the dash, and then secure using the
factory screws removed in Dash
Disassembly. (Figure C)
6. Attach the panel clips onto the radio
trim panel, and then clip the panel
onto the completed assembly to
secure it to the dash.
ISO DDIN radio provision
1. Attach the radio brackets to the
radio using the screws supplied
with the radio. (Figure A)
2. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/
or Axxess. Test the radio for proper
operation.
3. Insert the completed assembly into
the dash, and then secure using
the factory screws removed in
Dash Disassembly. (Figure B)
4. Attach the panel clips onto the
radio trim panel, and then clip the
panel onto the completed assembly
to secure it to the dash.
Kit Assembly
3
(Figure A)
(Figure B)
(Figure A)
(Figure B)
(Figure C)