User Manual

REV. 4/5/2018 INST99-8909
3
KIT PREPARATION
KIT ASSEMBLY
1. Slightly loosen (4) screws securing
the radio. (Figure A)
2. If the vehicle is equipped with Starlink,
remove (4) screws securing the Starlink
module (shaded part in figure A) located
directly below the radio. The module
must be relocated lower in the dash
cavity to retain functionality with the
front speakers. (Figure A)
3. Remove (4) screws securing the lower
module, then remove the module.
(Figure A)
4. Secure the module to the radio brackets
using the factory screws. (Figure B)
Continue to Kit Assembly
1. Secure the pocket to the radio brackets
using the (4) #8 x 3/8” Phillips screws
provided. (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the bracket/pocket
assembly, then secure it using the
screws supplied with the radio.
(Figure B)
4. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or Axxess. Test the radio for
proper operation.
5. Secure the radio assembly to the dash
using the factory screws.
6. Attach the (4) panel clips provided onto
the radio trim panel , then snap the
panel over the radio assembly.
7. Reassemble the dash in reverse
order of disassembly to complete the
installation.
(Figure B)(Figure B)
(Figure A)(Figure A)