Quick Start Guide

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Car Audio Replacement Interface for Select Toyota Vehicles - Black

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

Metra. The World’s Best Kits.



INSTALLATION INSTRUCTIONS

99-8266

KIT FEATURES

• ISO DIN radio provision with pocket

• ISO DDIN radio provision

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets • C) Pocket • D) (4) #8 x 3/8” Phillips screws

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• 10mm Socket wrench

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................2

Kit Assembly

–ISO DIN radio provision with pocket ..................3

–ISO DDIN radio provision .....................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: TBA

Antenna Adapter: 40-LX11

A B C

Toyota Camry 2018-up*

*Visit MetraOnline.com for up-to-date vehicle speciﬁc applications.

Summary of content (4 pages)

PAGE 1
99-8266 I N S TA L L AT I O N I N S T R U C T I O N S Toyota Camry 2018-up* TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Preparation........................................................2 Kit Assembly –ISO DIN radio provision with pocket...................3 –ISO DDIN radio provision......................................3 *Visit MetraOnline.com for up-to-date vehicle specific applications.
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the dashboard trim panel below the climate controls. 2. For models with a push button start: Unclip the Start/Stop button trim panel and set it to the side. For models without a push button start: Unclip and remove the trim panel to the left of the radio/climate control panel. 3. Unclip and remove the lower dashboard trim panel directly above the glovebox. KIT PREPARATION 1.
PAGE 3
KIT ASSEMBLY ISO DIN radio provision with pocket ISO DDIN radio provision 1. Attach the radio brackets to the pocket using the (4) #8 x 3/8” Phillips screws provided. (Figure A) 1. Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Remove the metal DIN sleeve and trim ring from the aftermarket radio. 2. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio.
PAGE 4
99-8266 I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.