Quick Start Guide

REV. 11/1/2017 INST99-8265HG
3
KIT ASSEMBLY
ISO DIN radio provision with pocket
1. Attach the radio brackets to the radio
housing trim panel using the
(4) #6 x 3/8” screws supplied. (Figure A)
2. Mount the pocket to the radio brackets
with the (2) #8 x 3/8” Phillips screws
supplied. (Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the assembly and
secure with the screws supplied with
the radio. (Figure C)
5. Locate the factory wiring harness and
antenna plug in the dash and make all
necessary wire connections to the radio.
Metra recommends using the proper
mating adapters from Metra and/
or AXXESS. Test the radio for
proper operation.
6. Mount the new radio assembly into
the dash.
7. Reassemble the dash in the reverse
order of disassembly.
(Figure C)(Figure A)
(Figure B)