Owner's Manual

99-8232B
Dash Disassembly Kit Assembly
8. Remove(1)Phillipsscrewfrom
eachsideofthepocketbelowthe
radio/climatecontrolassembly.
(2screwstotal)(FigureG)
9. Unclipandremovethepocket.
(FigureG)
10.Remove(2)10mmboltsabove
theradio(behindthea/cvents)
and(2)10mmboltsfrombehind
theclimatecontrolthenunplug
andremovetheassembly.
(FigureH)
11. Remove(10)Phillipsscrews
securingthebracketstotheradio/
climatecontrolassemblyand
separatetheradiofromtheclimate
controls.(Retainthefactorypanel
clips,climatecontrols,brackets
andscrewsforuseduringkit
assembly).
 Continue to kit assembly
3
(Figure G)
(Figure H)
(Figure A)
ISO DIN radio provision with pocket
1. Removethefactorypanelclips
andattachtotheMetraradiotrim
panelinthesameorder.Thiskit
comeswithsixpanelclipsthat
willonlyworkwiththeuppersix
locationsaroundthevents.The
twolowerclipsmustbefactory.
2. Mounttheclimatecontroltothe
factorybracketswiththefactory
hardware.(FigureA)
3. Mountthepockettotheclimate
control/bracketassemblywith
the(4)#8x3/8”Phillipsscrews
supplied.(FigureA)
4. Slidetheaftermarketradiointothe
bracketassemblyandsecurewith
screwssuppliedwiththeradio.
(FigureA)
5. Locatethefactorywiringharness
inthedash.Metrarecommends
usingthepropermatingadapter
fromMetraorAXXESS.Re-connect
thenegativebatteryterminaland
testtheunitforproperoperation.
6. Mounttheradio/pocket/climate
controlassemblyintothedash.
7. Reassembledashinreverseorder
ofdisassemblyusingthe
99-8232Bradiotrimpanel.
 Continued on back page