Specifications

6
Attach the corresponding bracket to
the (2) ISO head units.
(Figure C)
2
D
1
Insert the DDIN trim plate into the
radio housing.
(Figure D)
3
Position the bracket/radio assembly
to the back of the radio housing and
secure with the (8) Phillips screws
provided. (Figure D)
4
STACKED ISO DIN HEAD UNIT PROVISION
99-7871
KIT ASSEMBLY
BACK
F
RONT
(6) METAL RETAINING CLIPS
(
5)
WHITE
PLASTIC
RETAINING
CLIPS
A
A2
B
C
NOTE: Secure the a/c vent, climate
control, hazard switch, and the pas-
senger air bag on/off light into the
99-7871 radio housing panel using
the factory hardware.
(Figure A1)
Position the (6) metal factory retain-
ing clips and (5) plastic white clips
onto the radio housing in the same
location as the factory radio/climate
control panel.
(Figure A2)
Remove the center bar from the 99-
7871 radio housing.
(Figure B)