Instructions/Assembly Guide

ManualsBrandsMetra ManualsCar Electronics & GPSDash Kit for Nissan Sentra 2020-Up - Black

Metra. The World’s Best Kits.



INSTALLATION INSTRUCTIONS

99-7638

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT COMPONENTS

• A) Radio housing (front) • B) Radio housing (rear) • C) Radio trim panel • D) Radio brackets • E) #4 x 3/8” Phillips screws (4)

• F) #6 x 3/8” Phillips screws (4) • G) Panel clips (3)

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• 10mm socket wrench

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: 70-7552

Antenna Adapter: 40-NI12

A B C

E F

Nissan Sentra 2020-Up

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle

speciﬁc applications

KIT FEATURES

• ISO DIN radio provision with pocket

• Painted with a gloss black face, silver trim, and a textured housing.

Summary of content (4 pages)

PAGE 1
99-7638 I N S TA L L AT I O N I N S T R U C T I O N S Nissan Sentra 2020-Up Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle specific applications KIT FEATURES • ISO DIN radio provision with pocket • Painted with a gloss black face, silver trim, and a textured housing.
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the trim panel behind the radio. There are (4) clips securing this panel to the dash. Use caution as the front of the trim panel can easily be damaged. (Figure A) Note: Dash vents may vary depending on Nissan model. 2. Remove (4) 10mm screws securing the radio. Take note that the lower radio brackets are angled inward, hiding the bottom (2) screws from being easily seen. Slide the radio out, then unplug and remove the radio.
PAGE 3
KIT ASSEMBLY 1. Attach (3) panel clips provided onto the radio housing (front). (Figure A) 6. Slide the radio into the radio housing assembly through the back, then secure it to the assembly using screws supplied with the radio. (Figure E) 2. Snap the radio housing (front) to the radio housing (rear), then secure using (4) #4 x 3/8” Phillips screws provided (Figure B) 3. Secure the radio brackets to the radio housing using (4) #6 x 3/8” Phillips screws provided. (Figure C) (Figure A) 4.
PAGE 4
99-7638 I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1187, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.