Quick Start Guide

REV. 6/3/2019 INST99-7637
3
KIT ASSEMBLY
1. Attach (3) panel clips provided onto the
radio housing (front). (Figure A)
2. Snap the radio housing (front) to the
radio housing (rear), then secure using
(4) #4 x 3/8” Phillips screws provided
(Figure B)
3. Secure the radio brackets to the radio
housing using (4) #6 x 3/8” Phillips
screws provided. (Figure C)
4. Clip the radio trim panel onto the radio
housing assembly. (Figure D)
5. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
6. Slide the radio into the radio housing
assembly through the back, then secure
it to the assembly using screws supplied
with the radio. (Figure E)
7. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
8. Secure the radio assembly to the dash
using the factory screws.
9. Snap the factory trim panel to the dash
to complete the installation.
(Figure A) (Figure D)
(Figure B) (Figure E)
(Figure C)