User Manual

REV. 1/18/2018 INST99-7633

FINAL ASSEMBLY SCREEN OPERATION

1. Locate the factory antenna connector in the dash and complete all necessary connections to

the radio. Metra recommends using the proper mating adapter from Metra and/or Axxess.

2. Before using the kit it must be programmed.

Attention! If the interface loses power for any reason, the following steps will need to be

performed again. Also, if installing an ASWC-1 connect it after you program and test the

interface/radio, with the key in the off position.

a. Turn the key (or push-to-start button) to the ignition position and wait until the factory

display screen comes on. The screen should come on within 30 seconds.

Note:

If the screen doesn’t come on, turn the key to the off position, disconnect the

interface, check all connections, reconnect the interface, and then try again. Also ensure

that the display harness is connected.

b. Refer to “Screen operation” and select “Maxima” for the vehicle.

c. Refer to “Screen operation” and select “OEM Backup Cam” if retaining the factory

backup camera.

d. Refer to “Screen operation” and select the proper display type. If the vehicle came

equipped with factory NAV, select NAV; non-NAV for models without factory NAV.

e. Test all functions of the installation for proper operation, before reassembling the dash.

3. Secure the completed assembly into the dash, and then reassemble the dash in reverse order

of disassembly.

• Go to – SETTINGS

• This is the main settings screen to access the factory settings, and also the settings within

the Axxess interface.

• All button functions are retained and controlled in the same manner that the factory

buttons were controlled. (Example: Tire Pressure, Fuel Economy, Brightness,

Clock Setting, etc.)

Settings screen