User Manual

REV. 1/18/2018 INST99-7633
7
CONNECTIONS TO BE MADE
(CONT.)
From the 32-pin harness with RCA jacks to the aftermarket radio:
• Connect the Red and White RCA jacks labeled “AUX Input” to the audio AUX-IN jacks of the
aftermarket radio.
• Disregard the Red and White RCA jacks labeled “From DVD”, they will not be used in
this application.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
Continue to Installing the Interface
Group 2 harness for models with factory NAV
From the 7633 harness to the aftermarket radio:
• Connect the Black wire with a ring terminal to chassis ground.
Note: Also connect the aftermarket radios ground wire to chassis ground.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue/White wire to the amp turn-on wire. This wire must be connected to hear
sound from the factory amplifier.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Blue/Pink wire to the VSS / speed sense wire.