User Manual

1.800.221.0932

MetraOnline.com

CONNECTIONS TO BE MADE

(CONT.)

• Disregard the Yellow RCA jack labeled “From DVD”, it will not be used in this application.

• If an aftermarket backup camera or external video source is desired to be displayed onto the

factory display screen instead of the factory backup camera, connect the Yellow RCA jack

labeled “Backcam” to the desired source.

Note:

If either of these methods are chosen, the option chosen must be enabled in

Camera Input settings.

From the 12-pin harness with RCA jacks to the aftermarket radio:

• Connect the Blue/White wire to the amp turn-on wire. This wire must be connected to hear

sound from the factory ampliﬁer.

• Connect the White RCA to the left front RCA output.

• Connect the Gray RCA to the right front RCA output

• Connect the Green RCA to the left rear RCA output.

• Connect the Purple RCA to the right rear RCA output.

12-pin pre-wired ASWC-1 harness:

• This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering

wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be

used, please refer to the ASWC-1 instructions for radio connections and programming.

Note:

Disregard the harness that comes with the ASWC-1.

Continue to Installing the Interface

For models

with

a BOSE ampliﬁer:

From the 7633 harness to the aftermarket radio:

• Connect the Black wire with a ring terminal to chassis ground.

Note:

Also connect the aftermarket radios ground wire to chassis ground.

• Connect the Yellow wire to the battery wire.

• Connect the Red wire to the accessory wire.

• If the aftermarket radio has an illumination wire, connect the Orange wire to it.

The following (1) wire is only for a multimedia/navigation radio that requires this wire.

• Connect the Blue/Pink wire to the VSS / speed sense wire.

• Tape off and disregard the following (9) wires, they will not be used in this application:

Gray, Gray/Black, Green, Green/Black, Purple, Purple/Black, White, White/Black, White/Blue

• Connect the Green/Purple wire with a female bullet connector, to the Green/Purple wire

with a male bullet connector.

Note:

If this step is not performed, the factory backup camera will not function.

• Connect the Red and White RCA jacks labeled “AUX Input” to the audio AUX-IN jacks of the

aftermarket radio.

• Disregard the Red and White RCA jacks labeled “From DVD”, they will not be used in

this application.