User Manual

REV. 1/18/2018 INST99-7633
5
CONNECTIONS TO BE MADE
• Tape off and disregard the following (1) wire, it will not be used in this application:
White/Blue
• Connect the Green/Purple wire with a female bullet connector, to the Green/Purple wire
with a male bullet connector.
Note: If this step is not performed, the factory backup camera will not function.
• Connect the Red and White RCA jacks labeled “AUX Input” to the audio AUX-IN jacks of the
aftermarket radio.
• Disregard the Red and White RCA jacks labeled “From DVD”, they will not be used in
this application.
• Disregard the Yellow RCA jack labeled “From DVD”, it will not be used in this application.
• If an aftermarket backup camera or external video source is desired to be displayed onto the
factory display screen instead of the factory backup camera, connect the Yellow RCA jack
labeled “Backcam” to the desired source.
Note: If either of these methods are chosen, the option chosen must be enabled in
Camera Input settings.
12-pin pre-wired ASWC-1 harness:
• This harness is to be used along with the optional ASWC-1 (sold separately) to retain steering
wheel audio controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for radio connections and programming.
Note: Disregard the harness that comes with the ASWC-1.
Continue to Installing the Interface
Group 1 harness for models without factory NAV
For models without a BOSE amplifier:
From the 7633 harness to the aftermarket radio:
• Connect the Black wire with a ring terminal to chassis ground.
Note: Also connect the aftermarket radios ground wire to chassis ground.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Blue/Pink wire to the VSS / speed sense wire.