Owner's Manual

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

Re-connect the battery terminal and test the unit

for proper operation. Mount the head unit/kit

assembly to the sub-dash with (4) Phillips screws

previously removed in step #1.

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

"A"

"B"

Mount the factory cupholder to the bottom of the Radio Housing with (2) Phillips screws

previously removed in step #1 ("A") and (2) locating pins ("B").

rev. 250701