Quick Start Guide

REV. 6/12/2019 INST99-7387HG
9
(ASWC-1) STEERING WHEEL CONTROL SETTINGS
(CONT.)
Changing radio type
If the L.E.D. flashes do not match the radio you have connected, you must manually program the
ASWC-1 to tell it what radio it is connected to.
1. After (3) seconds of turning the key on, press and hold the Volume Down button on the
steering wheel until the L.E.D. in the ASWC-1 goes solid.
2. Release the Volume Down button; the L.E.D. will go out indicating the ASWC-1 is in
Changing Radio Type mode.
3. Refer to the Radio Legend to know which radio number you would like to have programmed.
4. Press and hold the Volume Up button until the L.E.D. goes solid, and then release. Repeat
this step for the desired radio number you have selected.
5. Once the desired radio number has been selected, press and hold the Volume Down
button on the steering wheel until the L.E.D. goes solid. The L.E.D. will remain on for about
(3) seconds while it stores the new radio information.
6. Once the L.E.D. goes out, the Changing Radio Type mode will then end. You can now test
the steering control wheel controls.
Note: If at any time the user fails to press any button for a period longer than (10) seconds, this
process will abort.
Continued on the next page
Radio legend
1 flash - Eclipse (Type 1) †
2 flashes - Kenwood ‡
3 flashes - Clarion (Type 1) †
4 flashes - Sony/Dual
5 flashes - JVC
6 flashes - Pioneer/Jensen
7 flashes - Alpine *
8 flashes - Visteon
9 flashes - Valor
10 flashes - Clarion (Type 2) †
11 flashes - Metra OE
12 flashes - Eclipse (Type 2) †
13 flashes - LG
14 flashes - Parrot **
15 flashes - XITE
16 flashes - Philips
17 flashes - TBA
18 flashes – JBL