Quick Start Guide

REV. 6/12/2019 INST99-7387HG
7
PROGRAMMING THE ASWC-1 AND CLIMATE DISPLAY
Programming the ASWC-1:
1. Press and hold the Volume Up button on the steering wheel, then turn the ignition on. The
L.E.D. will start flashing rapidly, which means the ASWC-1 is looking for the vehicle and
the radio.
Note: If the L.E.D. did not start flashing rapidly, press the reset button for 3 seconds.
2. After a few seconds the L.E.D. should stop flashing rapidly, and then go out for
approximately 2 seconds.
3. After approximately 2 seconds there will be a series of 7 Green flashes, some short, and
some long. The long flashes represent the wires that are connected to the ASWC-1.
Tip: Knowing this will help to troubleshoot, if need be.
4. The L.E.D. will pause for another 2 seconds, and then flash Red up to 18 times depending on
which radio is connected to the ASWC-1. Refer to the L.E.D. Feedback section for information.
5. This is the end of the auto detection stage. If the ASWC-1 detected the vehicle and the radio
successfully, the L.E.D. will light up solid. Release from holding the Volume Up button.
Programming the climate display:
7. Turn the parking lights on.
8. Turn the vehicles light dimmer all the way down, then all the way up.
9. Turn the lights off.
10. Test all functions of the installation for proper operation, before reassembling the dash.
Refer to the ASWC-1 Steering wheel control settings for customizing the buttons,
if so desired.
1. Secure the radio assembly to the dash using the factory screws.
2. Reassemble the dash in reverse order of disassembly to complete the installation.
FINAL ASSEMBLY