Quick Start Guide

REV. 6/12/2019 INST99-7387HG
5
CONNECTIONS
From the wiring harness included with the kit to the aftermarket radio:
• Connect the (2) Black wires, and also the Black wire labeled “CAMERA GROUND”, to the
ground wire, and also to the Black wire from the AX-CAM6V.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Red wire labeled “6-volt camera power” to the Blue/Red wire from the
AX-CAM6V.
• Connect the Blue/White wire from the AX-CAM6V to reverse power. This wire will have to be
sourced in the vehicle.
• Connect the Blue wire to the power antenna wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
The following (1) wire is only for a multimedia/navigation radio that requires this wire.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• If retaining the factory AUX-IN jack, connect the Red and White RCA jacks to the audio
AUX-IN jacks.
• Connect the Yellow RCA jack to the backup camera input.
Continued on the next page