Quick Start Guide

1.800.221.0932
|
MetraOnline.com
10
(ASWC-1) STEERING WHEEL CONTROL SETTINGS
(CONT.)
Remapping the steering wheel control buttons
Once the ASWC-1 has been programmed, the button assignment for the steering wheel controls
may be reassigned if so desired. For example, if the Seek Up button is preferred to be the Mute
button instead. Follow the steps below to remap the steering wheel control buttons.
1. Ensure the ASWC-1 is visible so you can see the L.E.D. flashes to confirm button recognition.
Tip: Turning the radio off is recommended.
2. Within the first twenty seconds of turning the ignition on, press and hold the Volume Up
button on the steering wheel until the L.E.D. goes solid.
3. Release the Volume Up button, the L.E.D. will then go out; The Volume Up button has now
been programmed.
4. Follow the list in the Button Function Legend to reference the order in which the steering
wheel control buttons need to be programmed.
Note: If the next function on the list is not on the steering wheel, press the Volume Up
button for (1) second until the L.E.D. comes on to skip that function, and then release the
Volume Up button. This will tell the ASWC-1 that this function is not available, and it will
move on to the next function.
5. To complete the remapping process, press and hold the Volume Up button until the L.E.D. in
the ASWC-1 goes out.
Button Function Legend
1. Volume-Up
2. Volume-Down
3. Seek-Up/Next
4. Seek-Down/Prev
5. Source/Mode
6. Mute
7. Preset-Up
8. Preset-Down
9. Power
10. Band
11. Play/Enter
12. PTT (Push to Talk)
13. On-Hook
14. Off-Hook
15. Fan-Up *
16. Fan-Down *
17. Temp-Up *
18. Temp-Down *
* Not applicable in this application
Note: Some radios may not have these commands. Please refer to the manual provided
with the radio, or contact the radio manufacturer for specific commands recognized by
that particular radio.
Continued on the next page