User Manual

99-7378B
3
Kit Preparation Kit Assembly
ISO DIN radio provision with pocket
1. Attach the pocket to the radio
brackets using the (2) supplied
#8 x 3/8” Phillips screws. (Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Attach the radio brackets to the
radio using the screws supplied
with the radio. (Figure B)
4. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for proper
operation.
5. Secure the completed assembly
into the dash using the factory
hardware, and then reassemble
the dash in reverse order of
disassembly.
From the factory radio/vent panel:
1. Remove (4) screws securing the inner radio trim panel to the panel, and then
unclip and remove. (Figure A)
2. Attach the 99-7378B radio trim panel to the factory radio/vent panel, and then
secure using the factory hardware. (Figure A)
Continue to Kit Assembly
REAR VIEW
OF
FACTORY RADIO/VENT PANEL
(Figure B)
(Figure A)
(Figure A)