Installation Guide

REV. 12/3/2020 INST99-7349B
3
KIT ASSEMBLY
(Figure A) (Figure B)
1. Secure the radio brackets to the pocket
using the (4) #8 x 3/8” Phillips screws
provided. (Figure A)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the bracket/pocket
assembly, then secure it using the screws
supplied with the radio. (Figure B)
4. Clip the radio trim panel over the radio/
pocket/bracket assembly. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapters from Metra or AXXESS. Test the
radio for proper operation.
6. Secure the radio assembly to the dash
using the factory screws.
7. Reassemble the dash in reverse order of
disassembly.