User Manual

99-7338
3
1. Snap the hazard button into the hazard switch bracket.
2 Attach the hazard switch assembly to the radio housing with the supplied
(4) 1/2” inch Phillips screws.
3. Attach the climate control to the radio housing using the factory hardware.
4. Attach the (9) panel clips in the same position as the factory radio trim
panel. (Figure A)
Note: If clips are not provided then please remove the factory clips and
re-use them.
Continue to kit assembly
Kit Preparation
(Figure A)
PLASTIC
PLASTIC PLASTIC
METAL
METALMETAL
PLASTIC
PLASTIC PLASTIC
Metal clips
Plastic
clips