User Manual

Axxess Interface Installation
4
Axxess Interface Installation 99-6514
• Provides accessory (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Used in amplified or non-amplified systems
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• High level speaker input
• Micro “B” USB updatable
• Retains balance and fade
• Ability to add aftermarket backup camera and additional video input
• Retains OE screen
FEATURES
• Cutting tool • Crimping tool • Tape • Connectors (example: butt-connectors,
bell caps, etc.)
TOOLS REQUIRED
• Interface • 16-pin harness with stripped leads
• 18-pin harness to 22-pin Chrysler harness with stripped leads
INTERFACE COMPONENTS
Connections to be made
From the 16-pin harness to the aftermarket radio:
• Connect the (2) Red wires to the ignition wire.
• Connect the Orange/White wire to the illumination wire. If the aftermarket radio
has does not have an illumination wire, tape off the Orange/White wire.
• Connect the Blue/White wire to the radio’s amp turn on wire.
• Tape up and disregard the Brown wire, it will not be used in this application.
The following wires are for the multimedia aftermarket radios that have
navigation/video built in.
• Connect the Light Green wire to the parking brake wire.
• Connect the Blue/Pink wire to the VSS or speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Plug the 16-pin harness into the interface.
Only make the following connections if the vehicle is amplified (If the vehicle is not
amplified disregard these wires).
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.