Installation Guide

REV. 8/13/2020 INST99-5856B
3
KIT ASSEMBLY
(Figure A) (Figure A)
(Figure B)
ISO DIN radio provision with pocket
1. Secure the sub-dash bracket into the dash
opening with either the factory screws or
the included screws.
2. Secure the pocket to the radio brackets
using the (4) #8 x 3/8” Phillips screws
supplied. (Figure A)
3. Remove the metal “DIN” sleeve and
trim ring from the aftermarket radio.
4.
Slide the radio into the bracket/pocket
assembly, then secure the radio using the
screws supplied with the radio. (Figure B)
5. Snap the hazard switch into the radio trim
panel from the front.
6. Snap the A/C vents into the radio trim
panel from the back.
7. Plug in the passenger airbag light and
hazard connections.
8.
Locate the factory wiring harness and antenna
connector in the dash, and complete all necessary
connections to the radio. Metra recommends using the
proper mating adapter from Metra and/or AXXESS.
9. Attach (4) panel clips to the radio trim panel,
then reassemble the dash in reverse order of
disassembly, using the 99-5856B radio trim panel.
10. Snap in the upper pocket to complete the
installation.
ISO DDIN radio provision
1. Secure the sub-dash bracket into the
dash opening with either the factory
screws or the included screws.
2. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
3. Snap the hazard switch into the radio
trim panel from the front.
4. Snap the A/C vents into the radio trim
panel from the back.
5. Plug in the passenger airbag light and
hazard connections.
6. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS.
7. Attach (4) panel clips to the radio trim
panel, then reassemble the dash in
reverse order of disassembly, using the
99-5856B radio trim panel.
8. Snap in the upper pocket to complete
the installation.