Installation Guide

ManualsBrandsMetra ManualsCar Electronics & GPSDash Kit for Ford Transit Connect 2014-2018 Vehicles - Matte Black

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

99-5856B

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT FEATURES

• ISO DIN radio provision with pocket

• ISO DDIN radio provision

• Passenger airbag indicator

• Painted scratch resistant matte black

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets • C) Sub-dash bracket • D) ISO-DIN pocket • E) (4) Panel clips • F) (4) #8 x 3/8” Phillips screws

• G) Upper pocket (not shown)

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

• T-15 Torx driver • T-20 Torx driver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly

–ISO DIN radio provision with pocket ..................3

–ISO DDIN radio provision .....................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: 70-5524

Antenna Adapter: 40-EU10

Ford Transit Connect (with AM/FM only radio)

2014-2018

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle

speciﬁc applications

A B C D E

Summary of content (4 pages)

PAGE 1
99-5856B I N S TA L L AT I O N I N S T R U C T I O N S Ford Transit Connect (with AM/FM only radio) 2014-2018 Visit MetraOnline.
PAGE 2
DASH DISASSEMBLY 4. Remove the A/C vents and hazard switch from the panel and set aside for kit assembly. 1. Remove the top panel above the storage pocket. (Figure A) 2. Remove (2) T-15 Torx screws above the display/radio panel. (Figure B) 5. Remove (4) T-20 Torx screws and remove the shaded factory sub-dash bracket. (Figure D) 3. Unplug and remove the display/radio panel. (Figure C) Continue to Kit Assembly 2 (Figure A) (Figure C) (Figure B) (Figure D) 386.257.1187 | MetraOnline.
PAGE 3
KIT ASSEMBLY ISO DIN radio provision with pocket 1. Secure the sub-dash bracket into the dash opening with either the factory screws or the included screws. 2. Secure the pocket to the radio brackets using the (4) #8 x 3/8” Phillips screws supplied. (Figure A) 3. Remove the metal “DIN” sleeve and trim ring from the aftermarket radio. 4. Slide the radio into the bracket/pocket assembly, then secure the radio using the screws supplied with the radio. (Figure B) 5.
PAGE 4
99-5856B I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1187, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.