Owner's Manual

ManualsBrandsMetra ManualsAudio accessories & installationDash Kit

REV. 4/20/2016 INST99-5832G

INSTALLATION INSTRUCTIONS FOR PART 99-5832G

METRA. The World’s best kits.

™

metraonline.com

CAUTION!

All accessories, switches, climate controls panels,

and especially air bag indicator lights must be connected before

cycling the ignition. Also, do not remove the factory radio with

the key in the on position, or while the vehicle is running.

• ISO DIN radio provision with pocket

• ISO DDIN radio provision

• Radio trim panel is painted gray

• A) Radio trim panel • B) Dash panel • C) Radio brackets • D) Pocket • E) Airbag light blank

• F) (4) #8 x 3/8” Phillips truss head screws • G) (2) #8 x 3/8” Phillips pan head screws • H) (3) Metal “U” panel clips

• I) (5) Metal “D” panel clips • J) (4) Small metal “D” panel clips • K) (4) Plastic panel clips

20;-,(;<9,:

20;*64765,5;:

• Panel removal tool • Phillips screwdriver

• Socket wrench • T-20 Torx screwdriver

;663:9,8<09,+

Ford Transit 2015-up

(without 4.2” screen)

99-5832G

Table of Contents

BDC

HI JK

Dash Disassembly ..................................................2

Kit Preparation ........................................................ 2

Kit Assembly

– ISO DIN radio provision with pocket ....................... 3

– ISO DDIN radio provision ....................................... 3

Final Assembly .......................................................3

>0905.(5;,55(*655,*;065: (sold separately)

Wire harness: • 70-5524 Antenna adapter: • 40-EU10

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 99-5832G Ford Transit 2015-up Table of Contents (without 4.2” screen) Dash Disassembly ..................................................2 99-5832G Kit Preparation ........................................................2 Kit Assembly – ISO DIN radio provision with pocket ....................... 3 20; -,(;<9,: • ISO DIN radio provision with pocket • ISO DDIN radio provision • Radio trim panel is painted gray – ISO DDIN radio provision ..............................
PAGE 2
99-5832G Dash Disassembly Kit Preparation 1. Unclip the dash panel above the radio. (Figure A) 2. Remove (2) T-20 Torx screws securing the factory radio/trim panel. (Figure B) 3. Unclip the factory radio/trim panel from the dash, unplug and remove. (Figure B) 4. Remove (1) T-20 Torx screw per vent then unclip and remove the vents from the factory radio/trim panel. (Figure C) 5. Unclip and remove the hazard switch assembly from the factory radio/trim panel. (Figure D) Continue to kit preparation 1.
PAGE 3
99-5832G Kit Assembly Final Assembly ISO DIN radio provision with pocket 1. Cut the shaded portion from the sub-dash of the vehicle to allow the radio to fit. (Figure A) 1. Attach the pocket to the radio brackets using the (4) supplied #8 x 3/8” Phillips truss head screws. (Figure A) 2. Remove the metal DIN sleeve and trim ring from the aftermarket radio. 3. Slide the radio into the completed assembly and then secure it using the screws supplied with the radio. (Figure B) 2.
PAGE 4
INSTALLATION INSTRUCTIONS FOR PART 99-5832G IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling. KNOWLEDGE IS POWER REV.