Owner's Manual

1.800.221.0932
|
MetraOnline.com
10
I N STA LL ATI O N
With the key in the off position:
1. Connect the CD player jumper harness to the wiring harness in the vehicle.
2. Connect the ASWC-1 harness to the wiring harness in the vehicle. Do not connect the ASWC-1
until the Axxess interface is programmed and fully functional.
3. Connect the 16-pin harness with stripped leads into the Axxess interface.
4. Connect the 3030 harness into the Axxess interface, and then to the wiring harness in the
vehicle.
5. Locate the factory antenna connector in the dash and complete all necessary connections to
the radio. Use the antenna adapter provided to adapt the factory antenna connector to the
aftermarket radio.
PROGRAMMING
Attention! If the interface ever loses power, the following steps will need to be performed again.
Please ensure that the owner of the vehicle knows this.
1. Temporarily connect the climate control while programming.
2. Turn the key to the ignition position and wait until the radio comes on .
Note: If the radio doesn’t come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface and then try agin.
3. Cycle the key off. If the driver’s door is closed, open and close the door. Cycle the key back on.
4. Test all funtions of the installation for proper operation, before reassemblying the dash.
5. Connect the ASWC-1 to the ASWC-1 harness, then program it per the vehicle specific install
instructions.