Quick Start Guide

ManualsBrandsMetra ManualsCar Electronics & GPSDash Kit for Select 2016 Chevrolet Cruze Vehicles - Matte black

REV. 10/26/2016 INST99-3020

INSTALLATION INSTRUCTIONS FOR PART 99-3020

METRA – The World’s best kits.

metraonline.com

CAUTION!

All accessories, switches, climate controls panels,

and especially air bag indicator lights must be connected before

cycling the ignition. Also, do not remove the factory radio with

the key in the on position, or while the vehicle is running.

• ISO DIN radio provision with pocket

• 99-3020B painted matte black

• 99-3020HG painted high gloss black

• A) Radio trim panel • B) Radio housing • C) Radio brackets • D) Pocket • E) (8) #8 x 3/8” Phillips screws • F) (6) Panel clips

KIT FEATURES

KIT COMPONENTS

WIRING & ANTENNA CONNECTIONS (sold separately)

Wiring Harness: • GMOS-LAN-10 • GMOS-MOST-01 Antenna Adapter: • 40-EU55

• Panel removal tool • Phillips screwdriver

• 5/16” socket wrench

TOOLS REQUIRED

Chevrolet Cruze 2016-up

99-3020B, 99-3020HG

Table of Contents

A B C D E F

Dash Disassembly ................................................. 2

Kit Assembly

– ISO DIN radio provision with pocket ...................... 3

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS FOR PART 99-3020 Table of Contents Chevrolet Cruze 2016-up 99-3020B, 99-3020HG Dash Disassembly.................................................. 2 Kit Assembly –. ISO DIN radio provision with pocket.......................
PAGE 2
99-3020 Dash Disassembly 1. Open the passenger door and glove compartment, then unclip and remove the trim panel on the side of the dash. 2. Unclip and remove the vent/trim panel above the glove box. 3. Unclip and remove the trim panel between the steering column and the climate controls. Kit Preparation 1. Remove the (1) 5/16” screw from the center of the dash cavity. 8. Unclip and remove the climate control panel, and then remove the (2) 5/16” screws now exposed. 2.
PAGE 3
99-3020 Kit Assembly ISO DIN radio provision with pocket 5. Locate the factory wiring harness and connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/ or Axxess. Test the radio for proper operation. 1. Attach the pocket to the radio brackets using the (4) #8 x 3/8” Phillips screws provided. (Figure A) 2. Remove the metal DIN sleeve and trim ring from the aftermarket radio. 3.
PAGE 4
INSTALLATION INSTRUCTIONS FOR PART 99-3020 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling. KNOWLEDGE IS POWER REV.