Quick Start Guide

99-3018
5
(Figure A)
(Figure B)
(Figure C)
1. Remove (4) Phillips screws to
remove the ashtray/pocket from
the bottom of the radio/climate
control panel. (Figure A)
2. Remove (4) T-10 Torx screws and
(16) Phillips screws to remove the
radio/climate controls, and radio/
climate bezel from the panel.
(Figure B)
Note: The radio/climate bezel will
not be used in this installation.
3. Remove (4) Phillips screws to
remove the upper screen
trim panel.
Remove shaded area
Kit Preparation
4. Cut the radio/climate control panel
clock support area as shown in
the diagram. (Figure C)
Note: Vent removal is optional.
5. Using the factory hardware, secure
the radio trim panel and the factory
radio/climate controls to the
modified factory panel. Use the (2)
supplied plastic washers on the top
two mounting positions.
(Figures D and E)
Continue to Kit Assembly
(Figure D)
(Figure E)