User Manual

6
Connections to be made
From the 3010S-LC harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Pink wire to the Pink wire located in the HVAC harness
(ignore the writing on this wire, this is NOT a “mute” wire).
• Connect the Blue/White wire to the power antenna wire.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
Installing the Axxess interface
With the key in the off position:
• Connect the 3010S-LC harness into the interface.
• Connect the 3010S-LC harness into the vehicle.
• With all connections completed, reconnect the negative battery terminal.
Initializing the Axxess interface
Attention: If the Axxess interface loses power for any reason,
the following steps will need to be performed again.
• Initialize the interface by turning the ignition on for 30 seconds,
then turn the ignition back off, then back on again.
• Start the vehicle, and then cycle the A/C fan speed all the way to high,
and then back to low.
Axxess interface installation 99-3010S-LC