Specifications

ALL VEHICLES

2-SHAFT HEAD UNITS: Snap the Faceplate into the Radio Housing. Slide the

aftermarket head unit into the kit and secure with shaft nuts. (See Fig. A)

ISO DIN HEADS UNITS:

Cut and remove the shaft supports from the Faceplate.

Snap the Faceplate into the Radio Housing. Slide the aftermarket head unit into

the back of the kit. Slide the ISO-DIN Brackets onto the Housing legs and align the

holes in the Brackets with the holes in the unit. Mount the Brackets to the unit with

(4) 5mm Flat-head Screws supplied ("A"). Mount the Brackets to the top of the

Housing legs with (2) #6 Self-tapping Screws ("B").

(See Fig. B)

99-3002

KIT ASSEMBLY/FINAL ASSEMBLY

DIN HEAD UNITS: If a surface-mount installation is desired, cut and remove the

shaft supports from the Faceplate. Snap the Faceplate into the Radio Housing. Slide

the DIN cage into the kit and secure by bending the metal locking tabs down. Slide

the aftermarket head unit into the cage until secure.

(See Fig. A). If an intermedi-

ate-mount installation is desired, attach the Snap Spacers to the outer walls of the

radio opening. Slide the DIN cage into the Radio Housing and secure by bending the

metal locking tabs down. Slide the aftermarket head unit into the cage until secure.

(See Fig. B). If flush-mount installation is desired, slide the DIN cage into the Radio

Housing and secure by bending the metal locking desired, slide the DIN cage into

the Radio Housing and secure by bending the metal locking tabs down. Slide the

aftermarket head unit into the cage until secure

. (See Fig. C)