Installation instructions

99-2022

Interface Installation

*Important: Before beginning any of the following, disconnect the negative battery

terminal to prevent an accidental short circuit.

1. From the 16-way harness:

• Connect the red wire to the ignition/accessory wire of the aftermarket radio

• Connect the Orange/White wire to the illumination wire of the aftermarket radio. If the

aftermarket radio has no illumination wire just tape off the Orange/White wire.

• Connect the blue/white wire to the amp turn on wire of the aftermarket radio.

• Connect the white wire to the left front positive speaker output of the aftermarket radio

• Connect the white/black wire to the left front negative speaker output of the

aftermarket radio

• Connect the gray wire to the right front positive speaker output of the aftermarket radio

• Connect the gray/black wire to the right front negative speaker output of the

aftermarket radio

• Connect the green wire to the left rear positive speaker output of the aftermarket radio

• Connect the green/black wire to the left rear negative speaker output of the

aftermarket radio

• Connect the purple wire to the right rear positive speaker output of the aftermarket radio

• Connect the purple/black wire to the right rear negative output of the aftermarket radio

• Connect the Brown wire to the mute wire of the aftermarket radio. If the aftermarket

radio does not have a Mute wire, tape up the Brown wire.

The following wires on the 16-pin harness are for the aftermarket radios

that have navigation built in:

• Connect the Light Green wire to the parking brake wire of the aftermarket

navigation radio.

• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket

navigation radio.

• Connect the Green/Purple wire to the reverse wire of the aftermarket navigation radio.

Continued on next page