User Manual

99-1008
Kit Assembly
(Figure A) (Figure A)
DIN radio provision with pocket
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the radio
housing and secure by bending the
metal locking tabs down. (Figure A)
3. Slide the radio back into the sleeve
until it clicks in.
4. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for proper
operation.
5. Secure the completed assembly
to the dash, and then reassemble
the dash in reverse order of
disassembly.
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Secure the ISO brackets to the
radio with the screws supplied
with the radio.
3. Slide the radio into the opening
until the side clips engage. (Figure A)
4. Snap the ISO trim plate into the radio
housing.
5. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for proper
operation.
6. Secure the completed assembly
to the dash, and then reassemble
the dash in reverse order of
disassembly.
3