Installation Guide

REV. 6/12/2018 INST95-HDIF-NP
7
KIT PREPARATION
(CONT.)
KIT ASSEMBLY
1. Secure the radio bracket to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the fairing and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or Axxess. Test the radio for
proper operation.
3. Reassemble the fairing in reverse
order of disassembly to complete the
installation, using the radio/bracket
assembly instead of the factory radio.
Due to differences in vehicle design,
optional spacers have been provided.
(Figure B)
(Figure B)
(Figure A)
Speaker grilles:
3. Screw the (4) #8-32 machine screws
provided into the holes in the speaker
ring that are countersunk. Take note that
the (8) holes in the ring are different.
The screws will need to be threaded into
the proper holes in order to retain the
screws. (Figure C)
4. Place the speaker grill onto the fairing ,
with the recessed portion towards the
back. Place the speaker ring on top of
the speaker grill . Secure the ring/grille
assembly to the fairing using the
(4) #8 x 5/8” Phillips screws provided.
(Figure D)
5. Place the factory speaker onto the ring/
grille assembly, lining up the holes in
the speaker with the (4) #8-32 machine
screws previously assembled. Secure the
speaker using the (4) #8 washers and (4)
#8-32 machine nuts provided. (Figure E)
6. Repeat steps 3-5 for the opposite side.
Continue to Kit Assembly
Optional spacers if needed
(Figure C)
(Figure D)
(Figure E)