Instructions/Assembly Guide

ManualsBrandsMetra ManualsCar Electronics & GPSDash Kit for Select Land Rover Vehicles - Black

Metra. The World’s Best Kits.



INSTALLATION INSTRUCTIONS

95-9406B

Caution! All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

KIT FEATURES

• ISO DDIN radio provision

• Painted scratch resistant matte black

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets • C) (4) #8 x 3/8” Phillips screws

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: See metraonline.com for wiring

harness options

Antenna Adapter: 40-EU10

A B C

Land Rover:

LR2 2008-2012

LR3 2005-2009

Range Rover Sport 2006-2009

Summary of content (4 pages)

PAGE 1
95-9406B I N S TA L L AT I O N I N S T R U C T I O N S Land Rover: LR2 2008-2012 LR3 2005-2009 Range Rover Sport 2006-2009 TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Assembly...........................................................3 KIT FEATURES • ISO DDIN radio provision • Painted scratch resistant matte black WIRING & ANTENNA CONNECTIONS (sold separately) Wiring Harness: See metraonline.
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the dash panel surrounding the radio. 2. Remove (4) screws securing the radio. 3. Pull up on the shifter knob to remove it. 4. Unclip, unplug and remove the center console panel. Please visit Metraonline.com for Dash Disassembly illustrations. 5. Remove the (2) screws securing the climate control panel. 6. Unclip and remove the A/C vent panel. 7. Pull the radio and the climate controls out slighly. The climate control does not need to be completely removed. 8.
PAGE 3
KIT ASSEMBLY ISO DDIN radio provision 1. Attach the radio brackets to the radio trim panel using (4) #8 x 3/8” Phillips screws supplied. (Figure A) 2. Slide the radio into the completed assembly, and then secure it to the assembly using screws supplied with the radio. (Figure B) 3. Locate the factory wiring harness and antenna connector in the dash, and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/or AXXESS.
PAGE 4
95-9406B I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 386-257-1187, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.