Quick Start Guide

ManualsBrandsMetra ManualsCar Electronics & GPSMetra - Dash Kit for Most 2005-2012 Land Rover Vehicles - Black

CAUTION!

All accessories, switches, climate

controls panels, and especially air bag indicator

lights must be connected before cycling the

ignition. Also, do not remove the factory radio

with the key in the on position, or while the

vehicle is running.

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

95-9404B

KIT FEATURES

• ISO DDIN radio provision

• Painted to match the factory ﬁnish

KIT COMPONENTS

• A) Radio housing • B) Radio trim ring • C) ISO DDIN sleeve • D) ISO DDIN brackets • E) Spacers • F) Removal keys • G) (2) Foam cushions• G) (4) Phillips screws

TOOLS REQUIRED

• Panel removal tool • Phillips screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................2

Kit Assembly ..........................................................3

WIRING & ANTENNA CONNECTIONS

(sold separately)

Wiring Harness: See metraonline.com for wiring

harness options

Antenna Adapter: 40-EU10

A B

Land Rover:

LR2 2008-2012

LR3 2005-2009

Range Rover Sport 2006-2009

F G H

Summary of content (4 pages)

PAGE 1
95-9404B I N S TA L L AT I O N I N S T R U C T I O N S TABLE OF CONTENTS Dash Disassembly...................................................2 Kit Preparation........................................................2 Kit Assembly...........................................................
PAGE 2
DASH DISASSEMBLY 1. Unclip and remove the dash panel surrounding the radio. 2. Remove (4) screws securing the radio. 3. Pull up on the shifter knob to remove it. 4. Unclip, unplug and remove the center console panel. 5. Remove the (2) screws securing the climate control panel. 6. Unclip and remove the A/C vent panel. 7. Pull the radio and the climate controls out slighly. The climate control does not need to be completely removed. Please visit Metraonline.com for Dash Disassembly illustrations.
PAGE 3
KIT ASSEMBLY ISO DDIN radio provision 1. Slide the ISO DDIN sleeve into the radio housing, then secure by bending the metal locking tabs outward (Figure A) 2. Slide the ISO DDIN sleeve/radio housing assembly into the radio cavity in the sub dash. (Figure A) 3. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/ or Axxess. Test the radio for proper operation. 4.
PAGE 4
95-9404B I N S TA L L AT I O N I N S T R U C T I O N S IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. Please have the vehicle apart and ready to perform troubleshooting steps before calling.