User Manual

ManualsBrandsMetra ManualsCar Electronics & GPSDash Kit for Most 2015-2016 BMW Vehicles - Black

Metra. The World’s Best Kits.

INSTALLATION INSTRUCTIONS

95-93 20B

Attention! Let the vehicle sit with the key

out of the ignition for a few minutes before

removing the factory radio. When testing the

aftermarket equipment, ensure that all factory

equipment is connected before cycling the

key to ignition.

KIT FEATURES

• ISO DDIN radio provision

• Retains the factory climate controls

• Retains the factory ambient ashtray light (if equipped)

• Includes all necessary data interfaces, wiring harnesses, and antenna adapter, for

a complete installation

•

Painted black to match the factory dash

KIT COMPONENTS

• A) Radio trim panel • B) Radio brackets • C) Panel clips (2) • D) Radio screws (8) • E) ASWC-1 interface and wiring harness (not shown)

• F) Axxess interface and wiring harness (not shown) • G) Ampliﬁer interface (not shown) • H) Antenna adapter (not shown)

BMW 2 Series* (with NBT iDrive, with MOST

Amp) 2015-2016

* F22, F23, F87

Visit MetraOnline.com for more detailed information about the product and up-to-date vehicle speciﬁc applications

A B C D

TOOLS REQUIRED

• Cutting tool • Panel removal tool

• Phillips screwdriver • 3mm Allen screwdriver

• T-20 Torx screwdriver

TABLE OF CONTENTS

Dash Disassembly ..................................................2

Kit Preparation .......................................................3

Kit Assembly ..........................................................4

Axxess Interface Installation .................................5

Final Assembly ..................................................... 10

WIRING & ANTENNA CONNECTIONS

Wiring Harness: Included with kit

Antenna Adapter: Included with kit

Steering Wheel Control Interface: Included with kit

Summary of content (12 pages)

PAGE 1
95-9320B I N S TA L L AT I O N I N S T R U C T I O N S BMW 2 Series* (with NBT iDrive, with MOST® Amp) 2015-2016 * F22, F23, F87 Visit MetraOnline.
PAGE 2
DASH DISASSEMBLY 1. Unclip, unplug, and remove the a/c vent panel above the radio. (Figure A) 2. Starting from the top, unclip and remove the panel below the climate controls. If an ashtray light is present, unclip and remove the light. (Figure B) 3. Remove (4) T-20 Torx screws securing the radio/climate-control panel, then unplug and remove the panel. (Figure C) Note: The bottom screws will be repurposed to install the radio assembly. (Figure A) (Figure C) (Figure B) (Figure D) 4.
PAGE 3
KIT PREPARATION Climate Control Assembly 1. Unplug the connector to the radio controls, then unclip and remove the climate controls from the radio/climate control panel. (Figure A) 2. Clip the climate controls into the radio trim panel. Ensure that the middle clip is lined up perfectly. (Figure B) 3. Attach the (2) panel clips provided onto the radio trim panel. (Figure A) (Figure C) Sub-dash Modification 4. Cut the sub-dash to allow room for the aftermarket radio.
PAGE 4
KIT ASSEMBLY 1. Secure the radio brackets to the radio using either the screws supplied with the radio, or the radio screws provided. (Figure A) Continue to Axxess Interface Installation (Figure A) 4 1.800.221.0932 | MetraOnline.
PAGE 5
AXXESS INTERFACE INSTALLATION INTERFACE FEATURES • Provides accessory power • Retains audio/phone† controls on the steering wheel • Provides NAV outputs (parking brake, reverse, speed sense) • Retains warning chimes through an outboard speaker • Comes with all necessary wiring to relocate the factory radio to retain vehicle settings • Retains the factory amplifier • Retains balance • Micro-B USB updatable TABLE OF CONTENTS Connections.........................................................................
PAGE 6
CONNECTIONS From the 9320 harness to the aftermarket radio: • Connect the Black wire to the ground wire. • Connect the Yellow wire to the battery wire. • Connect the (2) Red wires to the accessory wire. Note: There will an accessory wire from the ASWC-1 harness to connect as well. • Connect the Blue wire to the amplifier turn-on wire, and also to the Blue wire from the antenna adapter provided with the kit. • If the aftermarket radio has an illumination wire, connect the Orange wire to it.
PAGE 7
INSTALLATION The 9320 harness is a factory radio relocation harness which also provides power and speaker connections for the aftermarket radio. Connections will be made at the radio location first, then at the location where the factory radio will be relocated to, usually the trunk area. Ensure that the main 40-pin connectors are oriented in the correct way as they will only plug in if oriented properly. A harness layout has been provided at the end of this section. With the key in the off position: 1.
PAGE 8
PROGRAMMING 1. Press and hold the Volume Up button on the steering wheel. 2. Turn the ignition on, the L.E.D. in the ASWC-1 interface will start flashing rapidly, which means the ASWC-1 interface is looking for the vehicle and the radio. 3. After a few seconds the L.E.D. should stop flashing rapidly, then go out for approximately 2 seconds. 4. After 2 seconds there will be a series of 7 Green flashes, some short, and some long.
PAGE 9
HARNESS LAYOUT REV.
PAGE 10
FINAL ASSEMBLY 1. Secure the radio assembly to the dash using the factory screws. 2. Clip the radio trim panel to the dash, then secure it using the factory screws. If the vehicle is equipped with an ashtray light, attach it to the panel. (Figure A) 3. Reconnect and clip in the a/c vent panel back to the vehicle to complete the installation. (Figure A) 10 1.800.221.0932 | MetraOnline.
PAGE 11
REV.
PAGE 12
95-9320B I N S TA L L AT I O N I N S T R U C T I O N S If you are having difficulties with the installation of this product, contact our Tech Support line either by phone at 1-800-253-TECH, or email at techsupport@metra-autosound.com. Before doing so, look over the instruction booklet a second time and ensure that the installation was performed exactly as the instruction booklet is stated. Have the vehicle apart and ready to perform troubleshooting steps before contacting Metra/Axxess Tech Support.