User Manual

1.800.221.0932
|
MetraOnline.com
6
From the 9318 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the (2) Red wires to the accessory wire.
Note: There will an accessory wire from the ASWC-1 harness to connect as well.
• Connect the Blue wire to the amplifier turn-on wire, and also to the Blue wire from the
antenna adapter provided with the kit.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the Brown wire to the mute wire.
The following (3) wires are for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• Tape off and disregard the following (8) wires, they will not be used in this application:
Gray, Gray/Black, Green, Green/Black, Purple, Purple/Black, White, White/Black
• Connect the Red & White RCA jacks to the full range amplifier output jacks.
CONNECTIONS
From the ASWC-1 harness to the aftermarket radio:
This harness is to be used if the vehicle is equipped with steering wheel controls.
• Connect the Red wire to the accessory wire.
•
For the radios listed below: Connect the female 3.5mm connector with stripped leads, to the
male 3.5mm SWC jack from the ASWC-1 harness. Any remaining wires tape off and disregard
:
• Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/White
wire from the connector. Then connect the remaining steering wheel control wire,
normally Brown/White, to the Brown wire from the connector.
• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow wire
to the Brown wire.
Note: If the Kenwood radio auto detects as a JVC, manually set the radio type to Kenwood. Refer
to the Changing Radio Type document available at axxessinterfaces.com/product/ASWC
-1.
• XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately). Then connect the 4-pin connector from the AX-SWC-PARROT to the radio.
Note: The radio must have rev. 2.1.4 or higher software.
• Universal “2 or 3 wire” radio: Connect the steering wheel control wire, referred to
as Key-A or SWC-1, to the Brown wire from the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire from
the connector. If the radio comes with a third wire for ground, disregard this wire.
Note: After the interface has been programmed to the vehicle, refer to the manual provided with
the radio for assigning the SWC buttons. Contact the radio manufacturer for more information
.
• For all other radios: Connect the 3.5mm jack from the ASWC-1 harness into the jack from the
aftermarket radio designated for an external steering wheel control interface. Please refer to
the aftermarket radios manual if in doubt as to where the 3.5mm jack should connect to
.