User Manual

1.800.221.0932
|
MetraOnline.com
2
1. Unclip, unplug, and remove the a/c vent
panel above the radio. (Figure A)
2. Starting from the top, unclip and remove
the panel below the climate controls. If
an ashtray light is present, unclip and
remove the light. (Figure B)
3. Remove (4) T-20 Torx screws securing
the radio/climate-control panel, then
unplug and remove the panel. (Figure C)
Note: The bottom screws will be re-
purposed to install the radio assembly.
4. Remove either (2) or (4) T-20 Torx
screws securing the radio chassis,
depending on the radio equipped with
the vehicle. Slide the radio chassis out,
then unplug and remove. (Figure D)
Continue to Kit Preparation
(Figure B)
(Figure D)
(Figure A) (Figure C)
DASH DISASSEMBLY