Quick Start Guide

REV. 2/14/2018 INST95-9315B
3
KIT PREPARATION
(CONT.)
KIT ASSEMBLY
ISO DDIN radio provision
1. Attach the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
connector in the dash and complete
all necessary connections to the radio.
Metra recommends using the proper
mating adapter from Metra and/or
Axxess. Test the radio for
proper operation.
3. Secure the completed assembly into the
dash with the facory screws.
4. Reassemble the dash in reverse order
of disassembly using radio trim
panel assembly to complete the
installation.
(Figure A)
4. Attach the White connector from the
ribbon cable supplied with the kit to the
circuit board.
5. Reinstall the circuit board back into the
switch panel.
6. Clip the climate control panel, and
switch panel, into the radio housing.
(Figure C)
7. Attach the Black connector from the
ribbon cable to the climate control
panel. (Figure D)
For models without a switch panel below
the climate control.
8. Clip the switch panel cover to the radio
trim panel.
9. Disregard the ribbon cable, it will not be
used in this application.
Continue to Kit Assembly
(Figure C)
(Figure D)